You can easily select a post processor by right clicking a robot or a program. The choice of a post processor is assigned to a robot, therefore, changing the post processor assigned to a program will update the post processor used by all programs assigned to the same robot.

To select a post processor for a robot:

1.Right click a robot or a program

2.Select Select Post Processor

3.Choose a post processor from the list

4.Select OK.

Post Processors - Image 1 Post Processors - Image 2

The change is now applied, and the program can be generated again to see the result.

Note: The selection of a Post Processor is linked to a specific robot. Changing the post processor of a program will update the post processor for all programs linked to the same robot.

As an alternative, it is also possible to select the post processor by following these steps:

1.Open the robot panel (double click a robot)

2.Select Parameters

3.Select your post processor in the Robot brand box, as shown in the following image.

Tip: It is possible to quickly preview the output of each post processor by double clicking its PY file in the C:/RoboDK/Posts/ folder. More information available in the next section.

Select a Post Processor